Charge Regulator PWM60

The PWM 60 charge regulator is a high performance, low cost companion to all Selectronic SA22, SA32 and SA42 inverters. The SA22, SA32 and SA42 sinewave inverters come to you inclusive of Energy Management Mk II. This provides a fully featured monitoring and control system that allows you to keep track of vital system parameters, perform control functions and allow remote communications. Add a Remote Keypad, and you have at your fingertips all this energy information at a location that is removed from your inverter, such as the kitchen wall. Add a PWM60 Charge Regulator, and all solar, wind or hydro charging of your batteries can be controlled from your inverter by entering the float, boost and equalise voltage via the inverter keypad. The PWM60 also incorporates soft switching and is therefore gentle on your batteries, promoting increased battery life. Protect your valuable batteries from damage with the Selectronic PWM60 Charge Regulator. Rated at 60 amps, the PWM60 is reverse polarity protected, simple to install and simple to use. Safety & Standards At Selectronic we are serious about your safety so we have built the PWM60 to conform to the Australian Standard AS3100 (for electrical equipment). This means you can safely wire the relay into a normal electrical system. And as with all Selectronic products, the PWM60 conforms to the requirements of the Electromagnetic Compatibility framework (C tick), giving you low radio frequency interference. Reliability and Warranty At Selectronic we go to extreme lengths to make sure our products will continue to perform day in and day out. With an accredited Quality Assurance program (ISO 9001) in place and many hours of exhaustive field testing, you know you can rely on your Selectronic Inverter. As proof of our confidence, Selectronic provides a five year factory warranty on the PWM60.

SELECTRONIC PWM 60 SPECIFICATIONS

ELECTRICAL
PARAMETER	CONDITION	PWM 60 CHARGE REGULATOR
Output Current, 40°C Ambient	Max. Continuous Max. Surge	60A 120A
Output Current, 60°C Ambient	Max. Continuous Max. Surge	45A 90A
Charge Source Open Circuit Voltage Input Range		12 - 88V DC (Maximum of 40V difference between charge source and battery voltage)
Battery Voltage Range		12 - 24V DC Battery Bank (Maximum 40V battery voltage)
Input Current from Inverter, Terminal 6	Regulator OFF - No load Regulator ON - Full load	20mA DC 25mA DC
Switching Topology	Single Ended Pulse Width Modulation
Operating Temperature Range	0 °C to 60 °C
Conforms to Standards	AS3100 (wiring), C tick (EMI)
DC Isolation	None. Note that a single pole circuit breaker should be used. (Not included)
MECHANICAL
Size	195mm wide x 130mm high x 50mm deep.
Weight	1.0 kg
Weight packed	1.2 kg
Input lead Length	not applicable
Output wiring method	6 way screw terminal strip
Chassis	Powder Coated zinc steel (wedgwood blue)
Warranty	5 year parts and labour (conditions apply)

Through a policy of continued development, specifications or sizes quoted are subject to change without notice. Note: All power ratings are at 1.0 Power Factor. WARNING - All Remote Power System installations must comply with the relevant requirements of your state or national standards. It is imperative that only Registered Electrical Contractors are permitted to install or check any appliance or wiring in your installation. For information on where to buy the PWM60, see our list of Authorised Distributors. Manuals Download a copy of the operators manual. Brochures The product brochures are also available in a downloadable PDF form. Back